EUTECH INSTRUMENTS ALPHA COND 500 Spécifications télécharger pdf (Page 6)

2 PREPARATION

Remove screws from the four corners at the back of the Transmitter, and remove

back cover.

Connectors should be exposed as follows:

Figure 1 – Connection Guide

All wiring is done on 2 detachable connectors: –

1. 9-pin connector (located on SL1 position) for Conductivity electrode and

temperature sensor; &

2. 3-pin connector (located on SL2 position) for power supply.

Using a suitable screwdriver, loosen screws from top of connector.

When inserting the wires, always hold connector with top screws facing up.

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

Pas de commentaire

EUTECH INSTRUMENTS ALPHA COND 500 Spécifications Page 6