EUTECH INSTRUMENTS ION 700 - REV 3 Manuel d'instructions télécharger pdf (Page 16)

5. SETUP FUNCTIONS

Use the setup feature to customize your instrument operation.

There are two setup menus; one menu is derived from the %

saturation mode and the other from the mg/L (or ppm) concentration

mode.

First, select the appropriate measurement mode you wish to adjust by

pressing

until the desired units are displayed. During

measurement, press and hold

for 5 seconds to enter SETUP

mode of the parameter being measured.

Press

or to change programs or change options.

Press to select the program or confirm selection.

Press to go back one level or return to measurement mode.

5.1 1.0 CAL (Calibration)

Press

to view stored calibration points.

Note: % saturation mode will list two points, while

concentration mode has only one point.

5.2 2.0 ELE (Electrode Information)

Press

to view calibration factor (CAL.F)

TIP: The factor is an indication of the probe’s efficiency. It is

the ratio of the actual mV produced by the probe to the

theoretical mV value. The ratio displays from 0.5 to 1.999.

Press

to view mV output for 100% (HI).

Press

to view mV output for 0% (LO).

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 35 36

Pas de commentaire

EUTECH INSTRUMENTS ION 700 - REV 3 Manuel d'instructions Page 16