EUTECH INSTRUMENTS ECOSCAN TEMP 456 TEMPERATURE METER Manuel d'instructions télécharger pdf (Page 7)

2.3 Inserting & Removing the Rubber Boot

1. To remove meter from rubber boot, push out from the bottom edges of

meter until it is completely out of boot. Ensure that the connector of

temperature sensor is not connected.

2. To insert meter into rubber boot, slide in from the top of meter before

pushing the bottom edges of meter down to set it into position. Lift up the

stand at the back of meter for bench top applications if necessary.

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Pas de commentaire

EUTECH INSTRUMENTS ECOSCAN TEMP 456 TEMPERATURE METER Manuel d'instructions Page 7