EUTECH INSTRUMENTS ECOSCAN TEMP JKT PORTABLE METER Manuel d'instructions télécharger pdf (Page 6)

2.3 Inserting & Removing the Rubber Boot

1. To remove meter from rubber boot, push out from the bottom edges of meter

until it is completely out of boot. Ensure that the connector of temperature

sensor is not connected.

2. To insert meter into rubber boot, slide in from the top of meter before pushing

the bottom edges of meter down to set it into position. Lift up the stand at the

back of meter for bench top applications if necessary.

Figure 3: Inserting meter into the rubber boot

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Pas de commentaire

EUTECH INSTRUMENTS ECOSCAN TEMP JKT PORTABLE METER Manuel d'instructions Page 6