EUTECH INSTRUMENTS ION 700 - REV 3 Manuel d'instructions télécharger pdf (Page 11)

Instruction Manual pH 5+, pH 6+, Ion 6+

Changing the pH Buffer Group

1. Power off the meter while in pH mode. Press and hold then press . If

successful, “

” will blink on the display. Release both keys.

2. Press

to enter the buffer group selection mode.

3. Press

to toggle between the available pH buffer groups:

4. Press to confirm the pH buffer group. Note: If  is selected, measurement

mode will begin. If  or  is selected, proceed to step 5.

5. Press

to toggle between the desired number of calibration points (Pt). Note:

During pH calibration mode, the meter will automatically complete calibration after

the number of points selected here has been completed.

6. Press

to confirm the number of calibration points. The meter will automatically

begin to measurement mode.

To abor

t the buffer group selection or go back one step, press

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Pas de commentaire

EUTECH INSTRUMENTS ION 700 - REV 3 Manuel d'instructions Page 11