EUTECH INSTRUMENTS CYBERSCAN DO 5000 DO METER Manuel d'instructions télécharger pdf (Page 11)

Instruction Manual PD 300

To connect the DO/ temperature probe:

1. Line up the notch and 6 pins on the probe connector with the holes in the connector

located on the top of the meter. Push down and turn the metal locking ring clockwise to

lock the probe connector into place. See Figure 4.

2. To remove probe, unscrew the metal locking ring by turning the ring counterclockwise

and slide up the probe connector. While holding onto metal sleeve, pull probe away from

the meter.

NOTE

Do not substitute other DO probes. For a replacement DO probe, see the “Accessories”

section. Follow the same directions to connect an optional separate temperature element.

CAUTION: Do not pull on the probe cord or the probe wires may be damaged.

Figure 4: Connecting pH and DO/temperature probes

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 75 76

Pas de commentaire

EUTECH INSTRUMENTS CYBERSCAN DO 5000 DO METER Manuel d'instructions Page 11