EUTECH INSTRUMENTS WP PCD 650 Manuel d'instructions télécharger pdf (Page 30)

Instruction Manual PCD 650

2.3 Multi Display mode

PCD 650 lets you view multi measurement modes at the same time. The

measurement modes available for PCD 650 are pH/ mV/

Ion/Conductivity/Salinity/Resitivity/TDS/ DO(%)/DO (mg/L). The parameters being

displayed is based on the settings set in the Display Setup. For more information on

multi mode setup, refer ‘System Settings – Page 1’ on page 75 to select modes that

you would like to appear on the first, second and third row of the display.

Besides displaying the selected range, the meter also simultaneously displays the

temperature. The user can also set the meter to display temperature in the multi

measurement screen from in-built temperature of the COND & DO probes in the

system setup screen. (Refer ‘System Settings – Page 1’ on page 75 to set

temperature display)

Figure 21: Multi measurement screen

Refer respective measurement modes to get detail information on the indicators and

function keys that appear on the multi measurement screen.

For directions on how to calibrate your meter:

• See section 3.2 for Temperature calibration.

• See section 3.3 for pH calibration.

• See section 3.4 for mV calibration.

• See section 3.5 for Ion calibration.

• See section 3.6 for Conductivity calibration.

• See section 3.7 for Resistivity calibration.

• See section 3.8 for Salinity calibration.

• See section 3.9 for TDS calibration.

• See section 3.10 for DO(%) calibration.

• See section 3.11 for DO (mg/L) calibration.

In multi

measurement

screen, the lower

display shows the

temperature

reading and the

measurement

mode (from where

the temperature is

selected in system

setup). To display

temperature from

available modes,

refer Page 75.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 119 120

Pas de commentaire

EUTECH INSTRUMENTS WP PCD 650 Manuel d'instructions Page 30