EUTECH INSTRUMENTS WP PCD 650 Manuel d'instructions télécharger pdf (Page 96)

Instruction Manual PCD 650

4.7 TDS Setup

TDS setup screen present many options to control the operating parameters, which

can be controlled and set from the TDS setup screen. The settings are displayed in 2

pages. Press NEXT-P (F2) and PREV-P (F1) to navigate through these pages.

4.7.1 TDS Settings – Page 1

Figure 80 : TDS Settings - Page 1

This page allows you to set operating parameters for TDS measurement mode:

Parameter Description Factory

Default

The Pure water coeff, Lnr Temp Coefficient, normalization temperature, cell constant,

calibration due, calibration points are set the same way as previously described in

Conductivity set up. See ‘Conductivity Settings – Page 1’ on page 86.

TDS factor

The TDS conversion factor is the number used by the

meter to convert from conductivity to TDS. The TDS

conversion factor automatically adjusts the reading. The

TDS conversion factor can be set from 0.40 to 1.00.

For more information on TDS refer pages 27 and 106

0.500

NOTE: The factory default setting for the TDS conversion factor is 0.50.

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 119 120

Pas de commentaire

EUTECH INSTRUMENTS WP PCD 650 Manuel d'instructions Page 96